Smarthome 7307 Bedienungsanleitung

Total Protection Alarm SystemSMARTHOME™ #7307PAT. D410633Patents PendingSMARTHOME.COM™ 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com Orde

–18–SECONDARY PERSONAL IDENTIFICATION NUMBER (SPIN)You may want to give someone limited access to the system, (baby sitter,cleaner, repairman etc.). F

–20–ADVANCED PROGRAMMINGTo program sensors to send their signals to a different zone, you must firstclear them from communicating with their current z

–23–ADVANCED PROGRAMMING1. Enter the current MPIN.2. Press [ A ].3. Press [ A ].You will hear a long beep. The arm light, the red and green ligh

–25–Below is a table summarizing all the preprogrammed sequences.Sequence Zone 1 Zone 2 Zones 3 & 4 When sequence should be used

–27–BATTERY MAINTENANCEMOTION SENSOR BATTERYThe Motion Sensor operates on a 9 volt alkaline battery accessible beneath asliding panel on the bottom of

KEYCHAIN TRANSMITTER BATTERYThe Keychain Transmitter operates on a 12 volt alkaline battery which isinstalled at the factory.There are two screws on t

–2–Your Guide to theTotal Protection Alarm SystemSMARTHOME™ #7307–3–PACKAGE CONTENTS...

PACKAGE CONTENTSEverything required for installation is included with this package1 Control Panel (SC-001) includes:1 antenna (installed)1 AC adapt

–6–PLANNING YOUR HOME SECURITY NEEDSBefore you begin to install your security system, analyze the premises todetermine your security needs. Consider t

4. Attach the unit to the wall. If hanging theunit, insert two screws using the templateprovided. If screwing the back directly tothe wall, take the b

–10–(Cont. : Installing the motion sensor (PS-433)Set the switch on the side to "TEST" and allow 60 seconds for the unit to warmup. ( when u

LIGHTS AND SOUNDSIf you make a mistake while programming, the Control Panel emits threeshort beeps. That means the system has cleared and you must st

–14–STANDARD PROGRAMMINGOption 2: Home Sequence - To arm your system when someoneremains in the premises.1. Press the current MPIN [ 0 0 0 ].2. Pr

–16–KEYCHAIN TRANSMITTER (4B-434)TO DISARM THE SYSTEM, OR DEACTIVATE THE SIREN USINGTHE KEYCHAIN TRANSMITTERWhen the system is armed:Press button #3.T